Phillipp Tugend
- Total activity 201
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 6
- Subscriptions 153
Articles
Recent activity by Phillipp Tugend-
Worktop shown incorrectly in Elevation
Sometimes worktops are shown incorrectly in the Elevation. The reason is that the worktop is a single piece and requires cutting. This can be quickly done by using the Automatic cutting option. To...
-
How can I reset the plan to automatically created measurements?
Winner Design offers you the possibility to setup your own measurements, or to modify the existing automatically created measures.You can reset the measurements to the automatically created measure...
-
How to set up the overhang for covering panels
Covering panels can be edited so that they have an overhang in either the front of the units, the back or both. In Furnishing mode, Click F7 to open the Drawing settings window. In the middle of...
-
Display the internal contract number on a sales contract
If you use the internal contract number as leading number for your contract management, you can display the number directly on commercial printouts (like sales contract or invoice). To input an i...
-
Adding your supplier customer number
It is quite useful to store your customer number for certain suppliers directly in Winner Design. If you print an Order, the number will be printed on it. This means, the manufacturer can easily id...
-
How can I show hinges in the elevation view?
The hinge symbols on door fronts are deactivated by default. You can add the symbols by following the steps below: To show them in one Alternative Open Global settings on the Menu bar. Open the Sy...
-
Add a comment to a worktop for the supplier
It is possible to change the position of the worktop joints. See article How to insert or remove a joint in a worktop for detailed instructions. However, if you want to make changes to this and se...
-
How can I remove a cut out and renew the worktop?
Sometimes when you have completed a design your customer will want to change the position or the model of a sink or hob/cooker top. When you delete the existing item it will leave a cutout in your ...
-
How can I share my kitchen via social media?
It can be useful for promotional or other reasons to share designs on social media. Additionally, (initial) communication with a customer might happen on a social media platform. To do this you ne...
-
How can I add skirting board and or coving
Winner offers you the possibility to add coving and or skirting board to a room, including using skirting board as a plinth and coving on ceiling fillers. This is a decorative function that enhance...